DUMMY 26 July 2002
5-76
5.1.9 MEMORY ALL CLEAR (SP5-801)
Executing Memory All Clear resets all the settings stored in the NVRAM to their
default settings except the following:
SP7-003-1 Print total counter value
SP5-811 Machine serial number
SP5-907 Plug & play brand name and production name setting
Normally, this SP mode should not be used. This procedure is necessary only after
replacing the NVRAM, or when the copier malfunctions because the NVRAM is
damaged.
Using a Flash Memory Card
1. Upload the NVRAM data to a flash memory card (☛ NVRAM Data Upload).
2. Print out all SMC data lists (SP5-990).
NOTE: Be sure to print out all the lists. If the NVRAM data upload is not
completed, it is necessary to manually change the SP mode settings.
3. Open SP5-801.
4. Press the number for the item that you want to initialize. The number you select
determines which application software is initialized. Touch 1, for example, if you
want to initialize all modules; or select the appropriate number from the table
below.
No. What It Initializes Comments
1 All modules Initializes items 2 ~ 15 below.
2 Engine Initializes all registration settings for the engine and
process settings.
3 SCS (System Control
Service)/SRAM
Initializes default system settings, CSS settings,
operation display coordinates, and ROM update
information.
4 IMH (Image Memory
handler)
Initializes the registration setting for the image
memory handler. (Deletes all image files in the
HDD).
5 MCS (Memory Control
Service)
Initializes the automatic delete time setting for
stored documents.
6 Copier application Initializes all copier application settings.
7 Fax application Initializes the fax reset time, job login ID, all TX/RX
settings, local storage file numbers, and off-hook
timer.
8 Printer application Initializes the printer defaults, programs registered,
the printer SP bit switches, and the printer CSS
counter.
9 Scanner application Initializes the scanner defaults for the scanner and
all the scanner SP modes.
10 Network application Deletes the network file application management
files and thumbnails, and initializes the job login ID.
To Next Page
Loading...
