124
To transfer images in Mass Storage Mode, follow the
steps below:
1. Change [USB CONNECTION] to [MASS STR] on the Setup
menu.
2. Make sure that the camera power is off.
3. Connect the accessory USB cable to a USB port of your
computer.
4. Connect the USB cable to the USB
terminal of the camera.
The camera power becomes on.
Your computer automatically reads a file
necessary for recognizing the camera as a
drive.
After this preparation, the camera is displayed as a drive at My Computer
(Windows) or Desktop (Macintosh).
5. From the displayed drive,
copy a file to the desired
destination.
The figure at right shows the folder
configuration in a drive.
When the contents of the built-in
memory are displayed, the drive
name is RICOHDCI.
Caution
During transfer, do not disconnect the USB cable.
Note
When a SD memory card is inserted, its files are displayed. Otherwise, files in the built-in
memory are displayed.
Example of the Windows
XP screen
To Next Page
Loading...
