3. Paper Size and Paper End Detection
In B4 models, the paper size detector [A] on the FCU is located under the pa-
per holder. When a roll of A4/81/2" width paper is placed in the paper holder
and the paper guide [B] is installed in the paper holder, the paper guide acti-
vates the paper size detector. Thus, the machine determines which paper
size has been installed.
When the paper runs out, the actuator of the cover open/paper end sensor
[D] pivots into the sensor, and "REPLACE PAPER" is displayed.
When paper runs out while a received message is being printed, the machine
will operate as follows.
Machines without memory: The communication is terminated. Then the ma-
chine sends an error protocol signal to the sender.
Machines with memory: The received message is stored into the memory
(subsutitute reception). After recovering from the error, the message will be
printed.
[A]
[B]
H068D011.wmf
[D]
H068D008
DETAILED SECTION DESCRIPTIONS August 7th, 1995
PRINTING
2-8
To Next Page
Loading...
