Communication Switch 02
No FUNCTION COMMENTS
0
Burst error threshold
0: Low 1: High
If there are more consecutive error lines in the
received page than the threshold, the machine will
send a negative response.
The Low and High threshold values depend on the
sub-scan resolution, and are as follows.
Resolution Standard Detail
Low settings 3 6
High settings 6 12
1
Acceptable total error line
ratio
0: 5% 1: 10%
If the error line ratio of a page exceeds the acceptable
ratio, RTN will be sent to the other end.
2
Treatment of pages
received with errors during
G3 reception (BRO only)
0: Deleted from memory
without printing
1: Printed
0: Pages received with errors are not printed.
(BR1: Do not change the setting.)
3
Hang-up decision when a
negative code (RTN or PIN)
is received during G3
immediate transmission
0: No hang-up, 1: Hang-up
0: The next page will be sent even if RTN or PIN is
received.
1: The machine will send DCN and hang up if it
receives RTN or PIN.
This bit is ignored for memory transmissions or if ECM
is being used.
4
to
7
Not used Do not change the settings.
Communication Switch 03
No FUNCTION COMMENTS
0
to
7
Maximum number of page
retransmissions (BRO only)
00 - FF (Hex) times.
This setting is not used if ECM is switched on.
Default setting - 03[H]
(BR1: Do not change the setting.)
SERVICE TABLES AND PROCEDURES August 7th, 1995
BIT SWITCHES
4-24
To Next Page
Loading...
