Communication Switch 04
No FUNCTION COMMENTS
0
Reception mode switchover
from TEL mode to FAX
mode
0: Disabled 1: Enabled
These settings are available when bit 5 of user
parameter switch 7 is set to 1.
1: After picking up the handset, press the switchover
digit twice on the external handset’s keypad. Then the
machine automatically changes the reception mode.
For example, if bit 0 is at 1, the machinw will change to
FAX mode if it is in TEL mode.
NOTE: The switchover digit is programmed using bits
0 to 3 of Communication Switch 05. The default setting
is "2".
1
Reception mode switchover
from FAX mode to TEL
mode
0: Disabled 1: Enabled
2
Reception mode switchover
from AUTO mode to FAX
mode
0: Disabled 1: Enabled
3
to
7
Not used Do not change the settings.
Communication Switch 05
No FUNCTION COMMENTS
0
to
3
Digit for reception mode
switchover
00 - 09 (Hex)
4
to
7
Not used Do not change the settings.
Communication Switch 06 - Not used (do not change the settings)
Communication Switch 07 - Not used (do not change the settings)
Communication Switch 08 - Not used (do not change the settings)
Communication Switch 09 - Not used (do not change the settings)
Communication Switch 0A
No FUNCTION COMMENTS
0
Point of resumption of
memory transmission upon
redialing (BRO only)
0: From the error page
1: From page 1
0: The transmission begins from the page where
transmission failed the previous time.
1: Transmission begins from the first page.
(BR1: Do not change the settings.)
1
to
6
Not used Do not change the settings.
7
Emergency calls using 999
0: Enabled 1: Disabled
If this bit is at 1, the machine will not allow you to dial
999 at the auto-dialer. This is a PTT requirement in the
UK and some other countries.
August 7th, 1995 SERVICE TABLES AND PROCEDURES
BIT SWITCHES
4-25
To Next Page
Loading...
