8000A0[H] (0051A0[H]) - User parameter switch 00
Bit 0: Do not adjust
Bits 1 and 2: Scanning contrast home position
Bit 2 1 Setting
0 0 Normal
0 1 Lighten
1 0 Darken
Bit 3: Do not adjust
Bits 4 and 5: Scanning resolution home position
Bit 5 4 Setting
0 0 Standard
0 1 Detail
1 0 Fine
Bit 6: Transmission mode home position (BRO only) 0: Memory tx, 1: Immediate tx
Bit 7: Halftone home position 0: Disabled, 1: Enabled
8000A1[H] (0051A1[H]) - User parameter switch 01
Bits 0 to 6: Not used
Bit 7: Settings return to home position after transmission 0: Disabled , 1: Enabled
8000A2[H] (0051A2[H]) - User parameter switch 02
Bit 0: Forwarding mark printing on forwarded messages (BRO only) 0: Disabled, 1: Enabled
Bit 1: Center mark printing on received copies 0: Disabled, 1: Enabled
Bit 2: Not used
Bit 3: TSI included in transmitted messages 0: Disabled, 1: Enabled
Bits 4 to 7: Not used
8000A3[H] (0051A3[H]) - User parameter switch 03 (Automatic report printout)
Bit 0: Transmission result report (memory transmissions) (BRO only) 0: Off, 1: On
Bit 1: Not used
Bit 2: Memory storage report (BRO only) 0: Off, 1: On
Bit 3: Polling reserve report (polling reception) 0: Off, 1: On
Bit 4: Polling result report (polling reception) 0: Off, 1: On
Bit 5: Transmission result report (immediate transmissions) 0: Off, 1: On
Bit 6: Polling clear report 0: Off, 1: On
Bit 7: TCR (Journal) 0: Off, 1: On
8000A4[H] (0051A4[H]) - User parameter switch 04
Bits 0 to 6: Not used
Bit 7: Inclusion of a sample image on reports 0: Off, 1: On
8000A5[H] (0051A5[H]) - User parameter switch 05
Bit 0: Substitute reception (BRO only) 0: Off, 1: On
Bit 1: Memory reception if no RTI or CSI received (BRO only)
0: Possible, 1: Impossible
Bits 2 and 7: Not used
SERVICE TABLES AND PROCEDURES August 7th, 1995
SERVICE RAM ADDRESSES
4-62
To Next Page
Loading...
