Getting Started
39
3 Connect the USB cable to the USB
power adapter.
4 Plug the USB power adapter into a
power outlet.
The status lamp of the camera turns on and
charging starts.
Depending on the battery level, the charg-
ing time differs. An exhausted battery will
be fully recharged in about 2.5 hours (at 25°C
(77°F)).
When charging is complete, the status lamp
turns off. Unplug the USB power adapter
from the power outlet.
Storage Capacity --------------------------------------------------------------------------------------------
• About 200 pictures can be taken when the battery is fully charged.
• This is based on tests conducted according to CIPA standards under the following conditions: At 23°C
(73°F) temperature; the monitor is on; a picture is taken every 30 seconds; the camera is turned off
and back on after 10 pictures are taken.
• The storage capacity is for reference. For long periods of use, it is recommended that you carry spare
batteries.
Caution -------------------------------------------------------------------------------------------------------
• Use only genuine rechargeable battery (DB-110).
• If the battery starts to run down more quickly even after being charged, the battery has reached the
end of its service life. In this case, replace the battery with a new one.
• The battery may become very hot immediately after operation. Turn the camera off and leave it to
cool down sufficiently before removing the battery.
• If you turn the camera on while charging the battery, the charging is interrupted.
Memo ---------------------------------------------------------------------------------------------------------
• You can also charge the battery by connecting the camera to a computer using the USB cable. (p.110)
• The battery can also be recharged with the optional battery charger BJ-11.
3
4
To Next Page
Loading...
