9
Important: Confirm the following after attachment
Make sure that:
! Positioning projection [A] is visible
! The edge of the lower pressure spacer (B0514371) is aligned with the lower cover edge
[B], i.e. not positioned inside or projecting out from the cover edge.
Action 3 (parallelogram image of trimming pattern)
Adjust the position of the laser optics-housing unit as described in the Service Manual, pg.
3-11 to 3-14.
Adjusting for Image Skew
1. Positioning pin [A] (
!
x 1)
2. Loosen
!
(x 4) [B].
3. Adjust the position of the laser optics
housing unit (
☛
Adjustment).
4. Fasten
!
(x 4) [B].
NOTE:
After changing the position of
the laser optics housing unit,
do not reinstall the positioning
pin. Keep the pin in a safe
place.
B051R107.WMF
[A]
[B]
[
☛
NOTE]
To Next Page
Loading...
