Ricoh MP C4503 Technical Bulletin

Technical Bulletin PAGE: 5/5
Reissued: 27-Dec-16
Model: MET-C1ab, MET-C1ab_SOP
Date: 18-Jun-13
No.: RD147001w
Version
Modified Points or Symptom Corrected
The engine log data will be transferred before the machine shuts down in cases where
an engine SC has initiated an auto-reboot (which happens when SC auto-reboot is
enabled).
Sysmptom corrected:
1. The main motor does not stop turning if a non-feed jam occurs during a duplex job.
2. The fan does not stop turning if a job with mixed A3/DLT sizes is cancelled during
printing.
3. SC670 occurs if a paper jam occurs, a machine door or cover is opened, or other
operation that stops machine operation is initiated while Process Control is
underway.
4. Cannot print under the following conditions:
- Print job is initiated while the machine is in Energy Saver mode
- B/W duplex printing
- LT, LEF, plain paper
- First page of data is text only, second and later pages contain images
5. The paper feed motor may not stop when B5-LEF is fed from Tray 4.
6. Other changes:
The SP values listed below were changed for the following reasons:
- To prevent the issue of the ACC not stopping
- To prevent toner scattering
Note: The values vary depending on the model and destination.
SP3-234-011- 014, 021 - 024, 034, 050
SP3-624-007, 035, 071
SP3-627-001
1.24 :08
Symptom corrected
1. "Error" is displayed on the EFI controller screen (on the PC) for a very short time
while the machine is in Energy Saver mode.
2. SC452 occurs if the Energy Saver key is pressed while the front cover is open (EFI
controller).
1.23 :08
Symptom corrected:
A remote call for "Waste toner bottle Full" is mistakenly sent when the bottle is replaced
just following the Near Full condition.
1.22:08
Symptom corrected:
1. SC687 occurs when a copy is made using the exposure glass after the machine
recovers from Energy Saver mode.
2. SC544-02 and SC554-02 cannot be cleared by replacing the fusing unit and
executing SP5810-02 (hard high temp. detection).
Other changes:
3. When the printable area extension option is installed, it is possible to set
SP2-400-001 in order to switch between Process Control and fusing-related SP
settings.
1.21:08
1st Mass production

Ricoh MP C4503 Specifications

General

Print Speed	45 ppm
Print Resolution	1200 x 1200 dpi
Copy Resolution	600 x 600 dpi
Functions	Print, Copy, Scan, Fax
Print Technology	Laser
Type	Color Laser Multifunction Printer
Copy Speed	45 cpm
Fax Resolution	200 x 200 dpi
Duplex Printing	Yes
Monthly Duty Cycle	200, 000 pages
Standard Connectivity	USB, Ethernet
Paper Size	A3, A4, A5, B4, B5
Scan Resolution	Up to 600 dpi
Fax Speed	33.6 kbps
Memory	1.5 GB