Technical Bulletin PAGE: 2/3
Reissued: 26-Dec-16
Modified Points or Symptom Corrected
On machines with the language set to Russian, "No" is mistranslated to "Yes" in
the message that appears when printed from a USB memory stick.
Other changes:
The banner message that appears when a tray ascend/descend error occurs was
changed to indicate the tray.
For this release to take effect, make sure to update System/Copy v.1.26
(D1475575E) / v3.18 (D1465575E) for SOP or later as a set.
Specification Change:
Support for the Portuguese orthography.
- Traditional Chinese: "Print" is incorrectly displayed as "Copy" on the Print Volume
Use Limitation screen (System Settings).
1. Thumbnail view does not show correctly for received FAX documents.
Other changes:
2. The pop-up message that appears when the paper is not loaded correctly in the right
tandem tray was changed.
Old: "Reduce paper in the tray(s) to the limit mark and reset it correctly."
New: "Reduce paper in the tray(s) to the limit mark or reset it correctly."
Slow response of the operation panel.
1. Support for displaying the estimated time to obtain logs that are stored by using the
log-storing function.
2. Support for using the rear SD card slot to obtain logs that are stored on the device
by using the log-storing function.
This firmware is dependent on System/copy firmware v1.11(D1475550N) or later, so
please be sure to update it.
Other changes:
A touch screen function was added to the preview screen.
IMPORTANT: To apply the above change, in addition to this firmware, make sure to
update the System/Copy firmware to Ver.1.08 or later and all applications that use this
feature to the supported versions.
A login screen is displayed at power ON, which requires the Administrator or Supervisor
to set a password in cases where this password has not been set yet.
Modified Points or Symptom Corrected
On machines with the language set to Russian, "No" is mistranslated to "Yes" in
the message that appears when printed from a USB memory stick.
To Next Page
Loading...
