Ricoh MP C4503 - Page 38

Technical Bulletin PAGE: 1/3
Reissued: 22-Dec-16
Model: MET-C1ab
Date: 18-Jun-13
No.: RD147015p
RTB Reissue
The items in bold italics have been corrected or added.
Subject: Firmware Release Note: Printer
Prepared by: E. Hinata
From: 1st Tech Service Sect., MFP/Printer Tech Service Dept.
Classification:
Troubleshooting
Mechanical
Paper path
Product Safety
Part information
Electrical
Transmit/receive
Other (Firmware)
Action required
Service manual revision
Retrofit information
Tier 2
Important Information about Normal/Smart Panel Firmware Updates
 When updating machine firmware, make sure NOT to install Smart Panel supported
firmware on a machine with a normal operation panel (and vice-versa). If you do, the
machine may not function as designed and product warranty may not apply.
 To avoid this, when updating the firmware, make sure that the numbers next to "NEW" and
"ROM" are the same on the operation panel.
 If you install the wrong firmware, repeat the update procedure and check the numbers
mentioned above.
This RTB has been issued to announce the firmware release information for the Printer.
Version
Program No.
Effective Date
Availability of RFU
1.15
D1655701T
January 2017 production
Available
1.14
D1655701S
April 2016 production
Available
1.13
D1655701R
February 2016 production
Available
1.12
D1655701Q
November 2015 production
Available
1.11
D1655701P
June 2015 production
Available
1.10
D1655701N
April 2015 production
Available
1.09
D1655701M
December 2014 production
Available
1.08
D1655701L
August 2014 production
Available
1.07
D1655701K
March 2014 production
Available
1.06
D1655701J
January 2014 production
Available
1.05
D1655701H
December 2013 production
Available
1.04
D1655701G
November 2013 production
Available
1.03
D1655701F
September 2013 production
Available
1.02
D1655701E
August 2013 production
Available
1.01
D1655701D
1st Mass production
Available
Note: Definition of Availability of RFU via @Remote
“Available”: The firmware can be updated via RFU or SD card.
“Not available”: The firmware can only be updated via SD card.
Version
Modified Points or Symptom Corrected
1.15
Symptom corrected:
- After an SC reboot occurs, if the dialog window stating that the automatic
reboot has occurred is not closed, SDK-J applications cannot be started,
which results in an SC990 error occurring.
- An SC899 error might occur when the RHPP port (port 59100) receives specific
data.