Smart SDK.
- Screen may freeze, if logged in to the FAX application screen without the FAX
authentication enabled.
- Log-out button may not work, if logged in with the IC card right when the system
enters energy saving mode.
- On machines installed with CAP v2, the simple FAX application may shut down
abnormally, if an address registered without a FAX number is selected.
Other changes:
- Support for ErP Lot 6 compliance.
- Support for user code authentication in Web Browser NX.
- The following output check SPs were deleted:
- SP5-804-142：Toner Supply Motor Y: Standard Speed
- SP5-804-146：Toner Supply Motor M:CCW:Standard Speed
- SP5-804-151：Toner Supply Motor M:CW:(ITB Contact)
- SP5-804-155：Toner Supply Motor K: Standard Speed
- SP5-804-159：Toner Bottle Drive Motor Y
- SP5-804-160：Toner Bottle Drive Motor M
- SP5-804-161：Toner Bottle Drive Motor C
- SP5-804-162：Toner Bottle Drive Motor K
1. The machine reboots automatically after an SC670.
2. Added the following sub codes for SC670:
- SC670-03: Power source error for Engine.
- SC670-04:Communication error between CTL-IPU
Symptom Corrected:
1. SC878-03 may occur during a remote firmware update (RFU), if the SD card for FW
update is removed without turning OFF the machine power.
2. The printing speed is slow when printing multiple sets of duplex jobs from Color
Controller E-22C.
3. The machine may stall, if more than 57 jobs are run while a job is being interrupted.
4. SC641
5. Rarely, printing stops and does not resume with the operation panel displaying the
message "Please Wait."
6. Fax received is not printed and forwarded to the folder, if "Forwarding setting of
Reception File Setting" is enabled.
7. SC990 may occur with models installed only with the platen cover without the ADF.
8. The Start key is inactive after recovering from low power mode.
9. If "Function Priority" is set to an option other than "Home" and the steps below are
followed, the operation panel becomes inactive.
- Log in as any user.
- Press the Reset key on the Home Screen.
- Log out.
- Log in as a general user without the administrator authorization.
10. SC899 may occur after recovering from low power mode.
11. The FAX application icon may be relocated after a remote firmware update (RFU).
12. The Legacy FAX application icon may replaced with the Smart Apps icon.
13. When a site certificate is imported to the device from Web Image Monitor, an error
To Next Page
