Ricoh MP C4503 - Page 80

Technical Bulletin PAGE: 11/11
Reissued: 26-Dec-16
Model: MET-C1ab_SOP
Date: 01-Aug-13
No.: RD147031y
Version
Modified Points or Symptom Corrected
5. The following SP has been added in order that low power mode is available.
- SP5101-104 (low power mode entry setting): off (default)
- SP5101-004 (low power mode entry time setting): when SP5101-104 is on, this
setting is available.
- SP5101-008 (energy saver mode Key to Change Mode): in user tool, sleep
mode or low power mode is selectable.
6. Symptom corrected:
7. SC899 with a code "fcs" on SC Detailed Info of SMC may occur when a machine
recovers from sleep mode.
8. This firmware correction is dependent on the following firmware modules.
9. Please be sure to update it:
① Java VM v11.12.01 or later
10. When a machine send or receive high volume job with continuous it may be stalled.
11. A machine does not detect USB memory without encryption function after USB
memory with encryption function was inserted.
12. When summer time setting is on at southern hemisphere, day and time may delay.
13. A machine does not detect when USB memory is inserted to SD slot on the
operation panel.
14. Login and Logout is not performed when is failed at program registration setting.
15. SC899 may occur when authentication is set.
16. Login may fail when a user tries to log in a machine on which authentication is set.
2.21
Symptom Corrected:
[Embedded RC Gate]: "@Remote certificate updating..." is displayed and @Remote
communication is suspended if SSL communication with a router or proxy server was
suspended due to no response or detection of RESET signal.
Note: A certificate update indicates that a request to update the certificate was sent
to the @Remote Center instead of performing the retry process.
This firmware correction is dependent on the following firmware modules. Please be
sure to update it:
Network Support firmware v12.72.4 or later
When Chinese characters are included in the login user name, it might fail to
authenticate on the device.
This firmware is dependent on the following firmware modules. Please be sure to
update all of them:
Scanner firmware v02.12 or later
2.20
Symptom corrected:
Stored FAX documents cannot be viewed from inside WIM.
SC672-12 may occur when logging into SC mode just after the machine recovers from
Energy Saver mode.
Other changes:
"ID card copy" can now be registered and selected in User Tools.
2.19
1st Mass production