Ricoh Pro L5130 - Page 35

Overview Details Solution
Ripping an image with a very
large height fails.
Ripping fails in the following
conditions.
- Device configuration without
white ink
- Using PDF with spot colors.
- Image with large height
(Example)
Resolution: 600×600, Height:
Approx. 45,000 mm
Resolution: 600×900, Height:
Approx. 30,000 mm
Resolution: 1,200×1,200,
Height: Approx. 23,000 mm
If falling under these conditions,
take note of the image height.
Part of the folder location
does not appear.
If you specify a printer name
using 35 or more characters via
RIP-Queue, part of the folder
location does not appear.
This does not affect the folder
name.
Keep the printer name under 35
characters.
Part of the folder location
does not appear.
If you specify a printer name
including a single-byte hyphen
(-), the hyphen and the part of
the folder location following that
do not appear.
Do not include the hyphen (-) in
the printer name.
If printing a job with a very
long name, the application is
terminated forcibly.
If printing a job with a very long
file name exceeding 200
characters, the application may
be terminated forcibly.
Do not use a very long name for
the files.
The "Status" reports do not
match between RIP-Queue
and Job Editor.
The "Status" report in the Printer
area of RIP-Queue and that on
the [Print] tab of Job Editor do
not match.
The data reported via RIP-Queue
and Job Editor differs.
RIP-Queue reports the printer
status.
Job Editor reports the connection
status with RIP-Queue.
Restrictions on RIP-Queue
33