CIP Training L5160/L5130
Additional Features
New Cut Position
3. Select the position from where to cut media from either [Sheet Exit Position], [Position
of the cutter] or [Base line position on the media guide].
4. Press [Cut].
Start cutting at the cut position that you set.
* When [Sheet Exit Position] is selected, media is automatically fed from sheet exit
position to the media cutter position (about 60mm length) before starting to
cut.
-> Media is cut at the position indicated as red arrow in following figure.
* When [Position of the cutter] is selected, cutting start without media feeding.
-> Media is cut at the position indicated as blue arrow in following figure.
* When [Base line position on the media guide] is selected, media is automatically fed
from "scissor mark" on the media guide to the media cutter position (about 630mm
length) before starting to cut.
-> Media is cut at the position indicated as green arrow in following figure.
5. Press [Set].
To Next Page
Loading...
