CIP Training L5160/L5130
Additional Functions
[Parameters to be recorded]
Parameters Note Firmware
Media shape - -
Media type - -
Media width - -
Media thickness - -
Head height - -
Vacuum level - -
Auto detect media width - ON/OFF - *2 New
Auto detect media width - right side edge/width - *2 New
Special feed settings - *2 New
Special wind settings - *2 New
Drop position adjustment value *1 Each print mode -
Media feed adjustment value *1 Each print mode -
Media feed adjustment - Micro setting *1 E
ach print mode *2 New
Media feed correction *1 E
ach print mode *2 New
Heater ON/OFF *1 Each print mode *2 New
Heater temperature (Pre/Print/Post/Cure) *3 *1 Each print mode *2 New
(*1) These parameters are recorded for each print mode
(*2) These parameters can be recorded by new firmware described in the section "Before
You Start"
(*3) The temperatures are
saved when executing Media feed adjustment or Drop position
adjustment.
To Next Page
Loading...
