EasyManua.ls Logo

Ricon K Series - User Manual

Default Icon
14 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
32DSSK03.C
2 - 1
II. K-SERIES
®
DOT PRIVATE USE LIFT OPERATING INSTRUCTIONS
his chapter contains safety precautions, daily safety check instructions, control and indica-
tor descriptions, and operating instructions for the RICON K-Series
®
Private Use wheelchair
lift. This chapter must be thoroughly understood by operator before using lift.
A. SAFETY PRECAUTIONS
The following safety precautions must be complied with at all times when operating lift:
Refer to Figure 2-1. Deploying the lift when vehicle is on sloped ground is hazardous. Op-
erate lift with vehicle parked on level ground.
Vehicle must be safely parked with parking brake set before using lift.
Inspect lift before use. Do not use lift if an unsafe condition exists, or unusual noises or
movements are noticed, and contact a Ricon dealer or qualified service technician for re-
pair.
Read and comply with all warning labels and symbols affixed to wheelchair lift.
Refer to Figure 2-2. Wheelchair occupant must face outward on platform when entering or
exiting vehicle. Due to variations in the size and configuration of mobility aids, for maxi-
mum safety, Ricon recommends that passengers always face outward when riding the lift
platform.
It is never safe for a wheelchair occupant to exit a vehicle facing inboard. It is not safe to
rely on a threshold warning device (audible or other) to confirm that it is safe to exit vehicle
while facing inboard. Exiting the vehicle while facing outboard allows for visual confirma-
tion that the lift platform has been raised in the event that the threshold warning device is
inoperative or unheard and prevents the occupant from exiting the vehicle backwards when
the platform is still on the ground.
When exiting vehicle, verify that platform is at same height as floor and front rollstop is up
and locked.
T
FIGURE 2-1: SLOPED PARKING HAZARD
FIGURE 2-2: ALWAYS FACE OUTBOARD WHEN RIDING ON THE LIFT PLATFORM
-PRINT- -TABLE OF CONTENTS-

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Ricon K Series and is the answer not in the manual?

Overview

  1. Function Description
  2. Important Technical Specifications
  3. Usage Features
  4. Maintenance Features

The RICON K-Series® DOT Private Use Wheelchair Lift is a device designed to assist wheelchair occupants in entering and exiting a vehicle. This chapter of the manual provides comprehensive instructions for its safe and proper operation, including safety precautions, daily checks, control descriptions, and maintenance guidelines.

Function Description:

The K-Series® lift facilitates the movement of a wheelchair and its occupant between ground level and the vehicle floor level. It operates through a series of platform motions:

  • DEPLOY: The platform unfolds from its stowed position inside the vehicle to the floor level. If equipped with a power door operator, the vehicle doors open automatically before deployment.
  • DOWN: The platform lowers from the vehicle floor level towards the ground. The front rollstop automatically lowers (opens) when the platform reaches ground level.
  • UP: The platform rises from ground level towards the vehicle floor level. The front rollstop automatically rises (closes) when the platform leaves ground level.
  • STOW: The platform folds and retracts from the vehicle floor level to its stowed position. If equipped with a power door operator, the vehicle doors close automatically after the lift stows.

Important Technical Specifications:

  • Load Capacity: The lift is designed for a maximum load of 800 lbs (364 kg). It is intended for ONE wheelchair and its occupant.
  • Controls: The lift is primarily operated via a hard-wired, hand-held remote control pendant with two rocker switches (DEPLOY, DOWN, UP, STOW buttons). An alternate control switch is located on the left side platform armrest for UP and DOWN motions by the passenger.
  • Safety Features:
    • Vehicle Interlock System: Prevents lift operation if an unsafe condition is present (e.g., transmission not in park, parking brake not set). An interlock indicator light shows its status.
    • Outer Rollstop: Prevents slow or unintentional rolling off the platform. It is not designed to stop a quickly moving wheelchair.
    • Bridgeplate Load Sensor: Detects objects on the bridgeplate and inhibits platform lowering to prevent injury or damage.
    • Threshold Warning System: Uses two light beams to detect a passenger or object in the threshold area when the platform is one inch or more below the vehicle floor. An audible buzzer is actuated to warn users.
  • Circuit Breakers:
    • Main Circuit Breaker: Located in the vehicle engine compartment, it interrupts electrical power to the lift system in case of a major short circuit. It has a "flip-down" reset tab.
    • Optional Door Operator Circuit Breaker: Located on the hydraulic pump assembly, it protects the door operator from short circuits.
    • Control System Circuit Breaker: Also on the hydraulic pump assembly, it protects the control system from short circuits.
  • Pump Solenoid LED Status Indicator: A green LED located between the 8A and 30A circuit breakers monitors the condition of the two pump solenoids, indicating when the pump is operating.
  • Manual Backup Pump: Allows for manual operation of the lift if electrical power is not functioning. It includes a pump handle to raise the platform and a pump pressure release valve to lower it.

Usage Features:

  • Level Ground Operation: The lift must always be operated with the vehicle parked on level ground to prevent hazards.
  • Parking Brake: The vehicle must be safely parked with the parking brake set before using the lift.
  • Outward Facing: Wheelchair occupants must always face outward on the platform when entering or exiting the vehicle for maximum safety and visual confirmation of platform position.
  • Wheelchair Brakes: Wheelchair brakes must be locked before moving the platform. Power chair users should turn off power and set the brake.
  • Clearance: Ensure the area around and beneath the platform is clear of obstacles and other persons during operation.
  • Bridgeplate Safety: Do not stand on the bridgeplate as the platform lowers.
  • Stowing: The platform should always be returned to its stowed position inside the vehicle after use. Ensure the platform is completely stowed before closing vehicle doors to prevent damage.
  • Manual Operation: In case of power failure, the manual backup pump can be used. Instructions include overriding the Stow-Lock, using the pump handle to raise the platform, and the release valve to lower it. Caution is advised not to over-tighten the release valve or open it more than 1/4-turn to prevent disengagement.

Maintenance Features:

  • Daily Safety Check: Before each use, inspect the lift for proper function, unusual noises or movements, vehicle interlock operation, absence of interfering objects, satisfactory general appearance, lubrication, and tight fasteners.
  • Cycle Counter: Located inside the hydraulic pump housing, it tracks the number of complete lift cycles (from vehicle floor to ground and back to floor). This count is used to schedule maintenance operations.
  • Regular Maintenance: The manual emphasizes following lubrication, cleaning, and maintenance instructions provided in a dedicated chapter to optimize the lift's operating condition.
  • Professional Repair: If any unsafe condition, unusual noises, movements, or problems with circuit breakers persist after resetting, contact a Ricon dealer or qualified service technician for repair. Do not attempt to operate a damaged or malfunctioning lift.

Ricon K Series Specifications

General IconGeneral
BrandRicon
ModelK Series
CategoryMobility Aid
LanguageEnglish

Related product manuals