Ride1up Roadster V2 - Saddle and Seat Post Assembly; Seat Clamp Tightening

For the most up to date documents, bike models, additional information, instructional videos,
and more visit us at Ride1UP.com
9
3.3 Saddle/Seat Post Assembly:
• Open the seat clamp and insert the seat post to or past the minimum insertion point. (Figure 8
& 9)
• Adjust the suitable height and rotate the clamp to tighten and then shut it. (Figure10)
3.3 Seat Clamp Assembly:
• Slide saddle into seat post clamp.
• Using an 6mm hex wrench. Tighten the bolt to 16-17nm of torque unless otherwise marked on
part.
• The seat post angle is adjustable. Ensure the bolt is correctly torqued. If left loose or over-
tightened, the seat post bolt could snap causing serious injury and/or death.
9
8
10