RIDGID 690 - User Manual

Questions and Answers

T
Tonya Maldonado MDJul 26, 2025
What to do if my RIDGID Power Tool motor does not start?
- J
  John WilsonJul 26, 2025
  If the RIDGID Power Tool motor doesn't start, first ensure the power drive is plugged into a power source. Check the fuse and replace it if it's blown. Inspect the brushes; if they are worn, replace them. Overload due to dull dies can also prevent starting, so replace the dies if necessary. Ensure you're using adequate RIDGID thread cutting oil. Also, check that the brushes are making good contact with the brush holder by tightening the screws and ensuring the brush is firmly pressed onto the commutator.
S
Stephen TaylorAug 5, 2025
What to do if RIDGID Power Tool motor does not start because of dies?
- S
  Sonia GrantAug 5, 2025
  If your RIDGID Power Tool motor is not starting, check the dies. Dull or broken dies can cause the motor not to start, so replace them. Also, ensure the dies are set correctly and assembled in the correct sequence. Using low-quality pipe can also prevent the motor from starting; make sure only good quality pipe is used.
M
Megan GilmoreAug 16, 2025
How to troubleshoot start issues with my RIDGID Power Tool motor related to direction, oil, and support?
- P
  pittmanericAug 16, 2025
  If your RIDGID Power Tool motor isn't starting, verify the direction switch setting is correct. Ensure you are using adequate RIDGID thread cutting oil. Tighten the support arm feedscrew. Clean dirty support arm jaws with a wire brush. Make sure the support arm sits square on the pipe. Finally, eliminate any burr on the spline end of the die head with a file.