EasyManua.ls Logo

RIEJU MRT 50 - Vehicle Care and Storage; Cleaning Procedures; Lubrication and Protection; Long-Term Storage Preparation

RIEJU MRT 50
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CLEANING, LUBRICATION AND STORAGE
CLEANING. Frequent and thorough cleaning of your vehicle is an important part of mainte-
nance and will reduce the risk of corrosion and help the resale value if the vehicle looks good.
Near to areas in the sea or high mountain where salt is used on the road, we recommend a
cleaning or the vehicle after use to prevent corrossion by the effects of salt. It is important to
make a good clean at those points where the salt cumul.
I. Before cleaning:
a) Cover the end of the exhaust to stop water getting inside.
b) Make sure that the spark plug and filler caps are fitted correctly.
2. If the motor is very dirty or greasy, use a degreasing agent (Refer to note above.) Do not
apply this to the wheel axles or the chain, because that would remove any protective layer of
lubricant.
3. Using a hose pipe remove the degreasing agent and dirt, but only with the pressure that is
necessary. (DO NOT USE A PRESSURE WASHER.)
NOTE: Rieju is not responsible for the use of degreasing agents that may stain or mark the body
work or chassis.
Rieju is not responsible for the possible damage and wear and tear due to using a pressure
hose to clean the vehicle.
28
manual usuari mtr ang ok.qxp 06/03/2009 9:44 Página 28

Other manuals for RIEJU MRT 50

Related product manuals