To Next PageTo Next Page
Need help?Do you have a question about the Riello 40BF and is the answer not in the manual?
General| Fuel | Light Oil |
|---|---|
| Voltage | 230V |
| Frequency | 50Hz |
| Motor Power (kW) | 0.09 |
| Stages | One stage |
| Nozzle | Danfoss |
| Control | Riello |
| Pump pressure (bar) | 10 |
Ensures adequate air supply for proper burner operation.
Verifies chimney capacity, cleanliness, and absence of obstructions.
Stresses requirement for external oil filter and its maintenance.
Advises maintaining combustion area pressure close to zero.
Emphasizes adherence to electrical codes for connections.
Instructs on explaining burner operation to the homeowner.
Recommends installing a fire extinguisher if required by local codes.
Details fuel type, firing rates, electrical power, and pump pressure.
Provides physical dimensions for burner and flange mounting.
Illustrates and lists the identification of various burner parts.
Step-by-step guide for mounting with a universal flange.
Instructions for mounting the burner using a pedestal.
Wiring diagram for direct and low voltage primary control.
Details how to connect remote sensing for burner lockout.
Instructions for connecting a single line oil feed system.
Procedure for purging air from the pump in a single line system.
Procedure for purging air from the pump in a two line system.
Initial settings for BF3 burner based on firing rate and nozzle.
Initial settings for BF5 burner based on firing rate and nozzle.
