44
OPERATION
Modied service functions: (select the modied service functions and enter the values here).
Example: Vent Length Parameter changed from 1 to 2
Heating control:
Gas type setting (par 98 “Gas Type”) � NG | � LPG
CH set point (par. 3) : DHW set point (par. 48) :
Other:
Heating control programmed, notes:
� Documented the modied settings of the heating control in the control operating/ installation instructions
The following work has been carried out:
� Electrical connections checked, notes:
� Condensate trap lled � Carry out a combustion air/ue gas test
� Proper operation of all modes and settings check carried out � Leak test carried out on the gas and water sides
� Venting installed and secured properly per the vent manufacturer instructions
Commissioning includes checking the settings, a visual heating leak test and a functional check of the boiler and control. The system
installer conducts a test of the heating system.
This system has been checked to the extent described. The documents have been handed over to the home owner/op-
erator. The home owner/operator has been instructed regarding
safety and operation of the boiler and accessories, including the
need for regular scheduled maintenance.
Name of service installing contractor Date, owner/operator signature
Afx the test report here.
Date, system installer’s signature
To Next Page
Loading...
Need help?
General
