EasyManua.ls Logo

Riello MINI 13 - About the Riello Mini Boiler; Controls Interface Overview; Commissioning and First Start-Up

Riello MINI 13
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
RIELLO MINI
1.3 About the boiler
RIELLO MINI is a gas boiler with airtight cham-
ber and forced draft for the instantaneous
production of domestic hot water. Suitable to
operate with methane gas or with liqueed pe-
troleum gas (LPG).
The electronic control, the automatic ignition
and the continuous modulation allow to main-
tain the delivered water temperature constant
and to reduce the consumption of gas.
CONTROLS INTERFACE
C
DA
B
A
Main switch
Off
On
B
Temperature control
Allows to set the domestic hot water
temperature
C
Green signal
Flashing light to indicate the presence of
the power supply.
Fixed to indicate that the burner is on.
D
Red signal
Lights if a burner lockout occurs
1.4 Commissioning
The rst start up of the RIELLO MINI boiler
should be carried out by the Technical Assis-
tance Centre after which the boiler will be able
to operate automatically.
It may, however, be necessary to restart with-
out involving the Technical Assistance Centre:
for example after a long period of absence.
In such cases, the following checks and opera-
tions must be carried out:
Check that the gas shut-off valve and water
taps are open
Access the controls by pressing the top part
of the cover, lifting up the bottom edge and
allowing it to rotate carefully
C
DA
B
Turn the dial to “ON” and check that the
green light ashes
Turn the temperature control (B) by about
two thirds, if it has not already been set

Table of Contents

Related product manuals