Riello TAU 115 N - User Manual

Other manuals for Riello TAU 115 N

Instructions For The System Manager, Installer And The Technical Assistance Service40 pages

Questions and Answers

J
James StevensAug 10, 2025
Why my Riello Boiler does not reach its temperature setpoint?
- C
  Corey ZamoraAug 11, 2025
  If your Riello Boiler isn't reaching its set temperature, consider these possible causes and solutions: * A dirty boiler could be the culprit. Clean the flue gas pipes. * The heat exchanger and burner might be mismatched. Check their specifications and settings. * The burner capacity might be insufficient. Check and adjust the burner. * A faulty control thermostat could also be the problem. Check its correct functioning and temperature setting.
K
kyle30Aug 16, 2025
What to do if the safety valve keeps opening on my Riello TAU 115 N Boiler?
- P
  phillipssethAug 16, 2025
  If the safety valve on your Riello Boiler keeps opening, it could be due to: * Incorrect circuit pressure. Check the circuit pressure, pressure reducer functioning, and pressure reducer setting. * An issue with the CH expansion vessel. Check the efficiency of the expansion vessel.
R
rjonesAug 23, 2025
How to stop a Riello TAU 115 N from smelling of fumes?
- I
  Ian ClarkAug 23, 2025
  If you smell fumes coming from your Riello Boiler, it could be because fumes are escaping into the air. You should: * Clean the boiler body and the flue gas pipes. * Ensure that the boiler, flue pipes, and flue gas exhaust stack are all properly sealed.
T
Terri JacksonAug 28, 2025
Why is my Riello TAU 115 N Boiler generator at temperature but the heating system is cold?
- K
  Kimberly RuizAug 29, 2025
  If the generator of your Riello Boiler is at temperature but the heating system remains cold, the issue might be: * Air in the circuit. Bleed the circuit. * A malfunctioning pump. Check or unseize the pump. * A problem with the minimum temperature thermostat (if present). Check the temperature setting.
B
bscottSep 3, 2025
What causes condensate traces on the rear head of a Riello Boiler?
- D
  David MccallSep 3, 2025
  If you notice traces of condensate on the rear head of your Riello Boiler, the cause might be related to the flue gas box seals. Check the seals between the rear head and the flue gas box.

Riello TAU 115 N Specifications

General

Fuel Type	Natural Gas
Max Heat Output	115 kW
Efficiency	98%
Operating pressure	6 bar
Electrical supply	230V/50Hz
Protection rating	IPX5D
Type	Condensing
Modulation range	10:1