8
INPUTS
The four inputs, IN1 / IN2 / IN3 / SWMB, can be configurable or not according to different UPS series. Check the features that are
compatible and the default configuration in the chapter dedicated to your UPS model.
Some UPS may not handle all inputs.
OUTPUTS
For all UPS series, each of the eight outputs (OUT1 – OUT8) can be associated with an event such as an operating state or a
UPS alarm condition. You can also configure the function logic of the relay and set a delay for the event signalling.
The outputs can be configured via the configuration software of the UPS.
Check the default configuration of the outputs in the chapter dedicated to your UPS model.
In order to know the events that can be associated with the outputs, refer to the configuration software of the UPS.
Maximum ratings for each output
To Next Page
Loading...