32
RESIDENCE
USER GUIDE
Depending on the type of application, some of the functions described in this manual might not be available.
6 CONTROL PANEL
+ +
RESET
MENU
A C
1 2 3
A
It is normally used to raise the domestic hot water temperature, when the arrow is highlighted it has, however, the conrm
function
B
It is normally used to lower the domestic hot water temperature, when the arrow is highlighted it has the back/cancel
function
A+B
Access to the domestic hot water functions (only professionally qualied personnel)
C
It is normally used to raise the central heating water temperature, when the arrow is highlighted you can move within
the settings menu
D
It is normally used to lower the heating water temperature, when the arrow is highlighted you can move within the set-
tings menu
C+D
When heating programming timing is enabled, it allows you to pass from the automatic program to the manual one
A+C
Access to the clock settings menu (only professionally qualied personnel)
B+D
Access to the programming timing menu (only professionally qualied personnel)
1
Used to change the operating status of the boiler (OFF, SUMMER and WINTER)
2
Used to reset the alarm status or to interrupt the vent cycle
3
Used to access the INFO and SETTINGS menus. When the icon
is shown on the display, the key has the ENTER
function and is used to conrm the value set during the programming of a technical parameter
1+3
Lock and unlock keys
2+3
When the boiler is set to OFF it is used to start the combustion analysis function (CO)
B
D
To Next Page
Loading...
Need help?
General