35
INSTALLATION
Door - RTC 8000 - RTC 10000
Open the door, unscrew the nuts (1) securing the cover bracket (2)
and remove the bracket.
1
2
Hermetically close the door again by tightening the bolts (3) until
the door compresses the braided seal.
Top hinge
Loosen the nut (4) and remove the circlip (5).
Remove the through bolt (6).
4
6
5
Remove the four nuts (7) and remove the bracket (8).
8
7
Fit the hinge on the opposite side, reversing the steps described
above.
Bottom hinge
Loosen the nut (4).
Loosen the nut (5), unscrew and remove the through bolt (6).
5
4
Remove the four nuts (7) and remove the bracket (8).
8
7
Fit the hinge on the opposite side, reversing the steps described
above.
To Next Page
Loading...
Need help?
General