Need help?Do you have a question about the Riello RESIDENCE KIS Series and is the answer not in the manual?
Covers general safety rules, user responsibilities, installation, and maintenance advice.
Safety aspects for installation, including earthing, electrical connections, gas supply, and flue gas.
Details electrical safety, barefoot operation, modifications, ventilation, flammable materials, and gas valve precautions.
Further steps for filling and venting the heating system.
Step-by-step instructions for filling and venting the heating system.
Specifications and regulations for flue gas and air intake systems.
Explanation of the different access levels and password protection for parameters.
Essential checks to perform before the initial commissioning of the boiler.
Detailed steps for programming the heating ON and OFF times for each day.
Procedure for range rated adjustment and graphs showing fan speed vs. heat output.
How to enter and navigate the boiler configuration menu.
Steps to enable thermoregulation and select compensation curves.
Post-commissioning checks to ensure proper operation.
Instructions for converting the boiler between different gas types.
Initial startup procedure, including gas tap and firmware check.
How to set the desired domestic hot water temperature.
Step-by-step guide for performing a combustion analysis and its checks.
How to adjust the maximum heating output of the boiler.
How to reset the boiler and handle persistent faults.
How to enable and access the heating programming timing function.
How to set and understand the boiler's operating modes.
A comprehensive list of boiler error codes, their meanings, and alarm types.
A specific list of faults related to the combustion process.
Steps for reprogramming combustion parameters, especially after board replacement.
Essential safety measures and a list of common maintenance tasks.
Setting heating temperature manually without an outdoor sensor.
Steps to perform a safety stop in case of ignition faults or malfunctions.
Adjusting heating temperature when thermoregulation is active.
How to reset the boiler after an alarm or fault condition.
Introduction to DHW comfort modes like STANDARD and SMART.
Detailed explanation of the PREHEATING and TOUCH & GO functions.
How the system indicates faults, including icons and scrolling messages.
Specific steps for resolving pressure-related faults E041 and E040.
To Next Page
General