SMS Email – Email Contact(s)
When the EN pin has been activated, the CPU will email
the address listed in the pre-set receivers:
See the Message Text configuration section for details
on configuring the settings here.
NOTICE:
The email settings MUST be configured before the
CPU is able to send emails. See ‘Configuration of Email
Settings’.
SMS Message Input Output
Description of Function
This block can be used in a program where the sending
of a SMS message requires the receiver to provide an
acknowledgement SMS response.
Up to 12 of these blocks can be used in a program.
This block can be used when you require a SMS
message to be sent on an event AND you require an
acknowledgement from the receiver.
See SMS Message Input and SMS Message Output for
instructions on configuring this block.
To Next Page
Loading...
