Contact us at support@RIGDOO.tech
6) [Video Length]: Adjust individual video lengths.
3 seconds (Min) |
10 seconds (Default)
| 5 minutes (Max)
7) [Audio Recording]: Record sound or not.
On (Default)
| Off
8) [Shot Lag] : The interval between each trigger
2 seconds (Min) |
5 seconds (Default)
| 60 minutes (Max)
9) [Sensitivity Motion Sensors]: Adjust the sensitivity of motion
sensor.
Low | Middle
(Default)
| High
10) [Target Recording Time]: Want to set HT-20 to work in a certain
period?
Off (Default)
On
→ HT-20 will ask you to set the work time period.
(Requires entry of military time)
Sample: Start:21:00 | Stop: 06:00. HT-20 only work from PM
9:00 to AM 6:00.
11) [Time Lapse]: Change the camera from motion detection mode
to interval photo mode.
Off. (Default)
Normal
→ HT-20 will ask you to set the Interval time.
Sample: 30 seconds.
HT-20 will be take photo or record video per 30 seconds
TL video
→ HT-20 will ask you to set the Interval time.
Similar with TL normal mode, but will automatically stitch the
photos taken per 30 seconds into a video.
Note: Motion sensors deactivate when time lapse is turned
To Next Page
Loading...