Contact us at support@RIGDOO.tech
QUICK START GUIDE
Please refer to the instructions below for a quick start of your HT-20
We hope you can know the mode below before trying to use HT-20.
Power switch mode
"OFF": Power off, HT-20 won't do any things.
"TEST":
This mode is primarily used for camera setup and function
testing. In test mode, the HT-20 camera does not shoot
automatically. Instead, you can manually perform a shoot test.
The LCD screen will be bright in this mode.
On the top left corner of the LCD screen, you will find an icon
indicating the current work mode, and the number next to the
icon represents the camera's pixel parameter. Additionally, the
number on the top right corner of the screen indicates the
remaining capacity of the memory card, either in terms of
recordable length or the number of photos that can be taken.
This capacity figure is an estimate provided by the camera.
"ON":In this mode, the camera offers two shooting options based
on your settings: motion-triggered shooting and time interval
shooting. The shooting behavior depends on whether the TIME
LAPSE function is enabled or disabled.
If TIME LAPSE is turned off, the camera will capture photos or
To Next Page
Loading...