Rightline Gear 100A20 User Manual

2-Unzip the carrier and place it on top of the vehicle with
its non-zippered end facing front.
3-Load your gear within the shape of the carrier (Fig 1).
Place sharp edged items in the middle and softer items
around them.
WARNING: DAMAGE MAY OCCUR TO THE CARRIER
IF EXCESS MATERIAL FLAPS IN THE WIND.
TO ELIMINATE EXCESS MATERIAL, PACK THE CARRI-
ER FULL. IF UNABLE TO PACK FULL, FILL THE FRONT
CORNERS OF THE CARRIER AND PULL THE EXCESS
MATERIAL DOWN OVER THE SIDES. HOLD THE EX-
CESS MATERIAL SECURELY IN PLACE WITH THE CAR-
RIER’S STRAPS.
4-Close the zipper as you ll the carrier from the front to
the rear.
1-Remove the Car Clips from the (4) attachment straps (Fig
3); the Car Clips will not be used.
3-Attach each strap by wrapping it around the rack,
threading its end through its loop, and pulling tight (Fig 5).
4-Thread the straps up through slot A and down through
slot B of the buckles (Fig 6) and tighten the straps evenly.
Pack The Carrier
Attach The Carrier - WITH A Roof Rack
The correct attachment of this product is critical and
beyond the control of Rightline Gear. The safe use
and long life of this product depends entirely on
your good judgment and following these directions.
Fig 1
Fig 2
2-Decide if you will be attaching the straps to the roof
rack side rails or cross bars. If side rails, the straps will
connect to the side buckles (Fig 4). If cross bars, the straps
will connect to the front and rear buckles (Fig 4).
Ace Car Top Carriers 100A20, 100A10, 100A50
1-Clean the vehicle’s roof of all dirt and debris.
NOTE: REQUIRES SPACE UNDER THE ROOF RACK
SIDE RAILS OR CROSS BARS FOR THE CARRIER’S
ATTACHMENT STRAPS TO PASS THROUGH.
Fig 6
5-Tie off the strap ends so they don’t ap in the wind (Fig
7). Make sure to re-tighten the straps after a few miles
and check them regularly throughout the trip.
Fig 7
Hook-&-Loop Closures
Hook-&
-Loop
Closures
Protective Flap
Front
Fig 3
Fig 4
Fig 5
Side
Buckles
Rear
Buckles
Front
Buckles
Front
Side Rail
Side Rail
Cross
Bar
Cross
Bar
A
B
www.rightlinegear.com/setup.html
Set Up
Video:
5-Fold the protective ap down to secure the hook-&-loop
closures (Fig 1 and Fig 2). Make sure the hook-&-loop clo-
sures on the zipper ap completely overlap those on the
carrier. If it is difcult to secure the closures, the carrier is
over packed.
NOTE: IF A STRAP MAKES NOISE WHILE DRIVING,
LOOSEN THE STRAP, RE-POSITION IT SLIGHTLY,
AND RE-TIGHTEN IT.

Rightline Gear 100A20 Specifications

General

Brand	Rightline Gear
Model	100A20
Category	Automobile Accessories
Product Type	SUV Tent
Material	Polyester
Doors	1 door
Capacity	Sleeps 4 adults
Dimensions	96 x 96 x 84 inches
Water Resistance	Water-resistant
Compatibility	All SUVs, minivans, crossovers, wagons, and pick-up trucks with caps
Color	Gray
Setup Time	15 minutes
Poles	Fiberglass
Included Accessories	sewn-in setup guide

Summary

Pack The Carrier

Prepare Vehicle Roof for Packing

Clean the vehicle's roof of all dirt and debris before placing the carrier.

Position and Load Carrier

Place the carrier on the vehicle with the non-zippered end facing front and load gear, placing sharp items centrally.

Close Carrier and Secure Flap

Close the carrier zipper and fold the protective flap to secure hook-&-loop closures, ensuring overlap.

Attach Carrier With Roof Rack

Prepare Straps for Roof Rack Attachment

Remove car clips from straps and identify attachment points on side rails or cross bars.

Secure Straps to Roof Rack

Wrap straps around the rack, thread through loops and buckles, and pull tight.

Finalize Strap Security and Checks

Tie off strap ends to prevent flapping and re-tighten straps regularly during use.

Attach Carrier Without Roof Rack

Prepare Straps for Door Attachment

Start with car clips attached and align side buckles with vehicle doors for strap placement.

Secure Straps via Door Frame

Thread straps through buckles and hook car clips under door frame weather molding.

Tighten Straps and Re-check

Tighten straps evenly, shut doors over them, tie off ends, and re-tighten after initial miles.

Re-Connect Car Clips

Reconnect Clips to Attachment Straps

Run a strap's loop through a car clip, thread the strap end through its loop, and tighten.