Rigol DG1062Z

Chapter 2 Front Panel Operations RIGOL
DG1000Z User’s Guide 2-113
The option installation procedures:
 Edit the option installation file according to the above requirements
and store it into a USB storage device.
 Turn on the instrument and insert the USB storage device. Press Store
to enter the store and recall interface.
 Read the option installation file following the steps below in the store
and recall interface (refer to “Store and Recall”).
Select “D Disk”  set the file type to “All”  select the installation file
metioned above  press Read.
2) Install the option by sending SCPI commands
Open the remote control window and send the following option installation
commands by referring to “Remote Control
”.
:LICense:SET <license>
or :LICense:INSTall <license>
Wherein, <license>
is the option license (note that the hyphens should be
omitted).
For example, :LICense:INSTall SM9KD3YPMWNP2AQMST8J5H592EQT.
If the option is successfully installed, the prompt message informing you that
the option installation succeeds will be displayed; otherwise, the corresponding
error message will be displayed.