Rigol DG1062Z

Chapter 2 Front Panel Operations RIGOL
DG1000Z User’s Guide 2-115
 The filename suffix must be “.scpi”.
 The file content requirements:
The first line: the command used to lock the specified key;
The second line: a blank line (cannot be omitted).
Procedures:
 Edit the command file according to the above requirements and store it
into a USB storage device.
 Turn on the instrument and insert the USB storage device. Press Store
to enter the store and recall interface.
 Read the command file following the steps below in the store and recall
interface (refer to “Store and Recall”).
Select “D Disk”  set the file type to “All”  select the installation file
metioned above  press Read.
Filename Suffix
Blank Line
Command