Rigol DL3021 Quick Guide

RIGOL
12 DL3000 Quick Guide
English
Parameter Setting Method
Most parameters can be set by operating the keys on the front panel. The
common setting methods are listed below. The setting method for certain
parameters is different from the methods below, refer to the relevant chapters
of this manual for the further explanation.
Method 1: Use the numeric keys
1. In the main interface, press the specified menu key to switch the
parameter focus; in the guide interface, use the arrow keys to switch the
parameter focus.
2. Enter a value by using the numeric key. While entering a name, press
to delete the unwanted character if necessary.
3. When setting resistance, press the specified menu key and select "Ω" or
"kΩ" to be the unit.
When setting period/width, press the specified menu key and select "ms"
or "s" to be the unit.
When setting frequency, press the specified menu key and select "Hz" or
"kHz" to be the unit.
When setting other parameters, press OK to confirm the input.
Method 2: Use the knob or the arrow keys
1. In the main interface, press the specified menu key to switch the
parameter focus.
2. Press the Left/Right arrow key to move the cursor to a desired position.
3. Press the Up/Down arrow key or rotate the knob to modify the value.

Rigol DL3021 Specifications

General

Maximum Power	200 W
Maximum Voltage	150 V
Voltage Resolution	1 mV
Current Resolution	1 mA
Load Modes	CC, CV, CR, CP
Channels	1
Voltage Range	0 to 150 V
Display	4.3 inch TFT LCD
Interfaces	USB Host, USB Device
Voltage Accuracy	±(0.03% + 5 mV)