Rigol DP800A Series Performance Verification Manual

Chapter 3 Constant Current Tests RIGOL
DP800 Performance Verification Manual
3-17
Notes:
 For the single channel model with multiple ranges of DP800 series (DP811A),
please first select Range1, set the parameters of Range1 and measure the CC
programming and readback accuracy of this range in steps 3 and 4. Then,
repeat steps 3 and 4 to test the CC programming and readback accuracy of
Range2 (please replace the “P20V” or “LOW” in the remote commands in
steps 3 and 4 with “P40V” or “HIGH”).
 For the channels that support the Sense function of DP800 series, please
connect DP800, AC power supply, current sampling resistor and multimeter
according to Figure 3-2 and send the remote command
(DP821A: :OUTP:SENS CH2,ON; DP811A: :OUTP:SENS CH1,ON) to turn on
the Sense function of the channel under test before turning on the output of
the channel under test in step 3.
Test Record Forms:
Table 3-16 DP831A CC Programming and Readback Accuracy Test Record Form
Channel CH1 (8V/5A) CH2 (30V/2A) CH3 (-30V/2A)
Specification
Programming <20mA <9mA <9mA
Readback <20mA <7mA <7mA
The output current is 0
DP831A
Setting
Voltage 8.4V 32V -32V
Current 0A 0A 0A
Measurement
Result
U
1
I
1
=U
1
/R
M
[1]
I
2
Programming:
|I
1
-0|
Readback:
|I
2
-I
1
|
The output current is I
R
[2]
DP831A
Setting
Voltage 8.4V 32V -32V
Current 5A 2A 2A
Measurement
Result
U
3
I
3
=U
3
/R
M
[1]
I
4
Programming:
|I
3
-I
R
[2]
|
Readback:
|I
4
-I
3
|
Note
[1]
: R
M
=0.022Ω.
Note
[2]
: The rated current of the specified channel.

Rigol DP800A Series Specifications

General

Brand	Rigol
Model	DP800A Series
Category	Power Supply
Language	English