1 Product Overview 1-1. Introduction
- 5 -
1
1 Product Overview
1-1. Introduction
Thank you for your purchase of the GX-3R Pro Portable Gas Monitor (“product” hereinafter). First, confirm
that the model number of the product you purchased matches the model number of the product covered by
this manual.
The product should be used only by fully-trained personnel.
The maintenance procedures described in this manual should be performed only by fully-trained personnel.
Any maintenance procedure not described in this manual must be performed by Riken Keiki or our certified
service engineers. Please contact Riken Keiki.
This manual describes how to use the product and provides product specifications. Make sure you have read
and fully understand the contents of this manual before using the product. This applies both to first-time users
and those who have previously used the product.
Keep this manual in a safe place for future reference.
The contents of this manual are subject to change without notice to allow product improvements. Any
duplication or reproduction of this manual without permission is prohibited, whether in whole or in part.
In addition to this manual, manuals are also provided for optional products (sold separately). Refer to the
following manuals along with this manual when using optional products (sold separately):
1) RP-3R Pump Unit Operating Manual (PT0E-166)
2) SW-GX-3R Data Logger Management Program Software Operating Manual (PT0E-178)
3) SDM-3R Docking Station Operating Manual (PT0E-167)
Regardless of the warranty period, Riken Keiki does not accept any liability for accidents or damage resulting
from use of the product.
Be sure to read the warranty policy set forth on the warranty.
1-2. Intended use
The product is a multi-gas monitor equipped with up to four types of sensors to enable detection of five
different gas types using a single unit.
The detection target gases vary depending on the particular sensors installed in the product. Check the
detection target gases before use to confirm the correct gases will be detected in accordance with the
intended purpose.
The product is a gas detector designed to measure the concentrations of chemicals in the air in working
environments. It measures concentrations of toxic gases, combustible gases, and oxygen to which it is
exposed and issues an alarm if concentrations exceed preset levels, thereby alerting users to the hazards of
gas poisoning and oxygen deficiency.
To Next Page
Loading...
Need help?
General
