Riley RS3 - Folding Instructions; Uninstall;Install the Battery

13 14
2.4. Folding instructions 2.5 Uninstall/Install the battery
Uninstall
1. Push battery
clip in and hold.
2. Push the
battery up, away
from the bottom
of the stem.
3. After pushing
the battery up, pull
it out horizontally.
1. Insert the battery
horizontally into the
pole, while pushing
the battery clip in.
2. When in, let
go of the battery
clip, and push the
battery down
until rmly
secure.
Install
button
latch
latch
button
clip
1. Push down on
rear fender, pull up
the deck, and fold
towards the stem.
2. Press in button on
base plate clip, and
pull towards rear
fender to release.
3. Pull and hold
base plate latch and
push the rear of the
scooter towards the
front wheel.
4. Fold the scooter
rmly till it’s secure.
Resecure the base
plate clip to original
position.
5. Pull handle bar
release clips as
arrows indicate, and
completely fold handle
bars towards stem.
6. Slide button
upwards and unclip
stem clasp, fold
stem towards lower
stem.
7. Slide button
upwards and unclip
folding spanner.
Fold stem down to
base plate.
8. Slide folding latch
back, and align to the
hook on the base plate.
Release clip when aligned
to secure the stem.
View our
folding
video here