ring Alarm Keypad 2nd Generation - Page 5

Ring Alarm Keypad User Manual
Date:
Version: 0.1
Page: - 5 -
2. Locate the pinhole reset button on the back of the device.
3. With the controller in Remove (Z-Wave Exclusion) mode, use a paper clip or similar object and tap the pinhole button. The
device’s Connection LED turns on solid red to indicate the device was removed from the network.
Ring Alarm Keypad – Factory Reset
Factory Default Instructions
1. To restore Ring Alarm Keypad to factory default settings, locate the pinhole reset button on the device. This is found on the
back of the device after removing the back bracket.
2. Using a paperclip or similar object, insert it into the pinhole, press and hold the button down for 10 seconds.
3. The device’s Connection icon LED will rapidly blink green continuously for 10 seconds. After about 10 seconds, when the
green blinking stops, release the button. The red LED will turn on solid to indicate the device was removed from the network.
Note: Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Wake-Up Notification
Not applicable. Ring Alarm Keypad (LSS) is a Frequently Listening Receiver Slave (FLiRS) device and does not support Wake Up
Command Class.
Z-Wave Command Classes
Command Class
Version
Security Class
Required
Association
2
Highest Granted
Association Group Information
3
Highest Granted
Device Reset Locally
1
Highest Granted
Firmware Update Meta Data
5
Highest Granted
Indicator
3
Highest Granted
Manufacturer Specific
2
Highest Granted
Multi-Channel Association
3
Highest Granted
Powerlevel
1
Highest Granted
Security 2
1
None
Security 0
1
None
Supervision
1
None
Transport Service
2
None