ring Base Station - Page 2

Ring Base station – Inclusion
Adding device to a Z-Wave Network
Smart Start Inclusion Steps:
1. Initiate add device flow in the Ring Alarm mobile application – Follow the guided add flow instructions provided in the application
2. Scan the QR code found on the package of the device or the QR code found on the back of the device
Classic Inclusion Steps:
1. Initiate add device flow in the Ring Alarm mobile application – Follow the guided add flow instructions provided in the application
2. Select add manually
3. Select Z-wave and select Add
4. Enter learn mode on the joining device
Ring Base station – Learn Mode
Adding Base station to a Z-Wave Network
Ring Base station can be added via classic inclusion mode –
Classic Inclusion Steps:
1. Start inclusion mode on the primary controller
2. From the application’s UI, navigate to controller’s device setting screen -> select Advance options -> Select Z-wave from “Protocol
Adapters” and Select “Learn Mode” – DSK will be displayed (refer to the picture below)
3. Select “Begin Learn Mode” in the UI
4. When the inclusion process in complete, the LED on the base station will be solid blue