7
Tools and supplies you may need
for installation
Required supplies:
• Ring Retrofit Alarm Kit, with the included #1 Phillips head screwdriver
• A screwdriver that fits your existing wired alarm panel terminals
• A continuity tester or multimeter
Additional supplies you may need:
• A wire stripping tool
• Extra 20 or 22 gauge wire
• Twist on wire nuts or wire connectors
• Cleaning cloth or alcohol to clean the wall before using the included
mounting tape
• If you prefer to mount this device using screws, two screws and anchors to
mount the Retrofit Alarm Kit on the wall near your wired alarm panel,
plus a drill bit
• Masking tape and a pen, or some other method to label the wires
• If you plan to wire your Retrofit Alarm Kit through a hole in the metal alarm box,
make sure there is a rubber grommet around the hole to protect the wires
from damage. If it is missing, we recommend getting a replacement rubber
grommet at your local home improvement store.
To Next Page
Loading...
