| 11
Wireless connection
The Smart Life - Smart Living App is a third party application
independent of Rinnai. For this app to run, the home’s Internet router
must be running on 2.4 GHz (not 5 GHz)—check the wireless settings
on your device. It needs to be within 10 m of the water heater.
The main controls for the app are:
1. Adjusting the water temperature setting
2. Turning the system on and o
3. Checking and selecting dierent operation modes
4. Checking the timer
NOTE
1
2 3 4
1. Ensure mobile device is connected to the home router and Bluetooth is on. After the connection
is successful, you can turn o Bluetooth, the operation will not be aected.
2. Scan the QR code shown above or search for the app to download and install.
3. Open the app, register an account, and log in as prompted.
4. To connect the controller to your network press and hold the On/O and the Up keys together
for ve seconds to enter into manual network connection mode. When the controller is
available for connecting to a wireless network the wireless icon will ash, and if successful
this icon will remain continuously lit. You will need to repeat this step if the icon stops ashing
during the connection.
5. Connect to the SmartLife app as shown below.
6. Control the heat pump with the app.
To Next Page
Loading...
Need help?
General
