Why won't my Rinnai Grill burner ignite using the igniter?
If your Rinnai Grill burner isn't igniting, the gas cylinder valve might be off. Ensure the gas cylinder valve is turned 'ON'. Alternatively, the cylinder might be empty; replace it with a full one. If these steps don't work, there may be an issue with the ignition system or a blockage in the gas injector, and you should contact Rinnai.
What to do if my Rinnai GT104BHB fails to light?
If your Rinnai Grill fails to light, first check if the burner tubes are properly aligned over the orifices and reposition them if necessary. Inspect the igniter junction box behind the control panel and connect any loose electronic wires. Also, check the position of the sparker; the gap between the electrode tip and receiver should be about 4-5 mm, adjust if needed. Replace the AA battery in the igniter, if it is weak.
Why is the burner flame erratic on my Rinnai Grill?
An erratic burner flame on your Rinnai Grill could be due to several reasons. The burner might be incorrectly fitted; ensure it's properly installed. It could also be dirty or blocked, requiring cleaning. A nearly empty gas cylinder can also cause this issue, so replace it with a full one. If these steps don't resolve the problem, the regulator or injector may be faulty, and you should contact Rinnai.
What to do if gas is leaking from my Rinnai Grill hose?
If gas is leaking from the hose or connections of your Rinnai Grill, it could be due to a deteriorated hose, a faulty gas valve, or damaged threads. In any of these cases, contact Rinnai for assistance.
To Next Page
General
