What to do if there is flame failure or low gas flow in my Rinnai HD210e Water Heater?
To address flame failure or low gas flow in your Rinnai Water Heater, verify that the gas supply is turned on at both the water heater and the gas meter or cylinder. Also, ensure there are no obstructions blocking the flue outlet.
How to fix no ignition or no gas supply in Rinnai HD210e?
If your Rinnai Water Heater fails to ignite or seems to have no gas supply, first, check that the gas is turned on at the water heater itself. Then, check the gas meter or cylinder to ensure the gas supply is active there as well.
What to do if water will not flow after a power interruption during bath fill with my Rinnai HD210e Water Heater?
If you experience a power interruption while filling a bath and the water does not flow when the power is restored, turn off all hot water taps. Then, press the On/Off button twice on your Rinnai Water Heater.
Why is there a noticeable reduction in water flow in my Rinnai Water Heater?
If you notice a reduction in water flow in your Rinnai Water Heater, the inlet water filter may need cleaning. A service call is required to resolve this issue.
What to do if the wireless water controller for my Rinnai HD210e Water Heater is out of range?
If your wireless water controller (when fitted) for the Rinnai Water Heater is out of range, it may be due to the distance from the transceiver or an obstruction. Try moving the wireless water controller or transceiver closer, or remove any obstructions that might be interfering with the signal.
General| Maximum BTU Input | 199, 000 BTU/hr |
|---|---|
| Minimum BTU Input | 15, 000 BTU/hr |
| Category | Tankless |
| Fuel Type | Natural Gas |
| GPM at 70°F Rise | 5.2 GPM |
| Temperature Range | 98°F - 185°F |
| Vent Diameter | 3" |
| Electrical Requirements | 120V, 60Hz |
| Warranty | 12-year heat exchanger, 5-year parts, 1-year labor |
| Ignition Type | Electronic |
To Next Page