Rinnai MP2200 - Default Chapter; Table of Contents

Rinnai 3 Commercial Manifold Pack OIM
NOTE
INSTALLATION, SERVICE AND REMOVAL MUST BE BY AN AUTHORISED PERSON ONLY.
AS/NZS 5601 was current at the time of printing but may have been superseded. It is the Installer's
responsibility to ensure current requirements are met.
Remove transit protection lm. Check for damage, if any is found DO NOT install and contact
supplier.
TABLE OF CONTENTS
WARNINGS & IMPORTANT INFORMATION 4
Regulatory Information ....................................................................................................................................... 4
Warning About Hot Water ................................................................................................................................... 4
Model Range Overview ...................................................................................................................................... 5
Location .............................................................................................................................................................. 5
INTERNAL FLUEING 7
Co-Axial Flueing for Internal Models .................................................................................................................. 7
Common Flue System for Internal models ......................................................................................................... 8
INSTALLATION 10
Setting Sequence ............................................................................................................................................. 11
Manifold Pack with MECs or PAMs Staging (no reticulation system) ............................................................... 11
Manifold Pack without MECs or PAMs Staging (reticulation system) ............................................................... 11
Activated Manifold Pack without MECs or PAMs staging (reticulation system) ............................................... 12
Typical Rinnai Manifold Pack Installation ......................................................................................................... 13
Appliance Dimensions .................................................................................................................................. 13
Rinnai Manifold Pack Installation Hand Over Manual ...................................................................................... 15
Rinnai Manifold Electronic Control System - MECS ......................................................................................... 15
CONDENSATE DRAIN 16
REU-KM & REU-N Models Only ..................................................................................................................... 16
Installation Method ........................................................................................................................................... 16
FAULT FINDING 18
Manifold Pack Preventative Maintenance ........................................................................................................ 18
Ring Main Pump ............................................................................................................................................... 19
Service ............................................................................................................................................................. 19
Contacts 20