Page 13
Introduction
This portable air conditioner can alter the room temperature and humidity. It has multiple functions of cooling,
dehumidifying (drying) and fan ventilation, and can be moved from room to room and transported from building to
building easily. In addition, the desired humidity level can be set between 35-85%.
The air conditioner can maintain set room indoor air temperatures between 18°C and 32°C. The set room
temperature is displayed on the remote control and in the control panel on the unit. This does not mean that the
air conditioner will necessarily reduce the actual room temperature to the set room temperature. This appliance
operates at half the noise levels of most other portable air conditioners and is ideal for bedrooms.
This POLOCOOL portable refrigerated air conditioner model EX10C has a maximum cooling capacity of 2.5 kW.
This is sucient to cool rooms with a oor area of between 6 and 32 square metres.
y Do not place the air conditioner or plastic window slider in direct sunlight. Close all curtains in the room being
cooled.
y For maximum cooling (COOLING MODE), set the temperature at 18°C and the fan at HIGH. After
approximately 3 minutes, the compressor will turn on and cooled air will come out of the front air outlet. Warm
air will also come out of the rear outlet and into the exhaust hose.
y In COOLING MODE the air conditioner will not cool unless the set temperature is below the existing room
temperature.
y In COOLING MODE once the existing room temperature reaches the set temperature, the fan continues
operating and the compressor switches on and o to maintain the set temperature within the room.
y For maximum cooling output keep the exhaust hose as short and as straight as possible. Minimise bends which
can reduce the maximum cooling capacity of the air conditioner. Elevate the air conditioner if necessary.
y Make sure the air intake and outlet grills are unobstructed.
y Clean the lters at least once every two weeks.
Warnings and Important Information
Warning information regarding appliances with R290 refrigerant gas.
Thoroughly read all of the warnings.
The appliance must be installed, used and stored in a ventilated area that
is greater than 9m
2
.
The appliance must be placed in an area without any continuous sources
of ignition (for example: open ames, gas or electrical appliances in
operation).
y This appliance contains 270 g of R290 refrigerant gas.
y When cleaning the appliance, do not use any tools other than those recommended by the
manufacturing company.
y Do not puncture and do not burn.
y Refrigerant gases can be odourless.
y If the appliance is installed, operated or stored in a non-ventilated area, the room must be designed to prevent
the accumulation of refrigerant leaks resulting in a risk of re or explosion due to ignition of the refrigerant
caused by electric heaters, stoves, or other sources of ignition.
y The appliance must be stored in such a way as to prevent mechanical failure.
y Repairs must be performed based on the recommendations from the manufacturing company. Maintenance and
repairs that require the assistance of other qualied personnel must be performed under the supervision of an
individual specied in the use of ammable refrigerants.
Introduction
To Next Page
Loading...
Need help?
General
