EasyManua.ls Logo

Rippton INTREPID - 5. EKF; EKF Mode Functionality; 6. Charging; Boat Battery Charging Procedure

Rippton INTREPID
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5.
EKF
6.
CHARGING
For boat battery: Please charge the battery separately after taking it out of the battery compartment
(please refer to image above).
7.
MAINTENANCE OF BATTERY
To prevent over-discharge and avoid decreasing the battery lifetime, the battery should be fully
charged every month, as long-term storage will have a negative impact.
For long-term storage, please ensure the power switches of both the boat and its remote control
are turned off, and the power level is greater than 80%. If not, the battery will be over-discharged
due to a failure of normal use.
Storage temperature-20~25 (within 15 months)
8.
TROUBLESHOOTING
Why I cannot control my boat by remote?
S1: Check if the boat still stays on Auto Mode. If
this is the case, press and hold the “Enter/ESC”
button to exit such mode.
S2: Check if the boat still stays on Cruise Control.
If this is the case, pull down the joystick to exit it.
S3: The remote is out of power, the boat will
return to the home point by itself.
S4: The boat is out of power. Recall the boat
promptly when the battery voltage approaches
6.5V. Set the home point and low battery
return value before each voyage.