3.1.4.2 HOPPER RELEASE
3.1.4.3 CRUISE CONTROL
3.1.5 AUTO-OPERATION
3.1.5.1 HOME POINT SET AND USAGE
SET
a. Drive the boat to a point that you intend to set as the home point;
b. Short press down the joystick, a prompt box will pop up on the screen as follows:
c. Short press the “Enter/ESC” button, the screen will display the following prompts to indicate
success or failure.
Note: It is important to set the home point after calibration, even if you only wish to run the boat
manually. With the home point, the boat will be able to do the Return-to-Home by remote or
when low battery or signal lost.
Long press the “Hopper” button for 3
seconds, to drop baits/berleys in the hopper.
After dropping, please restore the hopper
board to the original position.
Long press the “Cruise Control” button for 3
seconds, to set the boat sailing automatically in
a straight line.
Pulling down the joystick is to quit the “Cruise
Control” mode.
To Next Page
Loading...