Note: Suggest using the boat normally after the signal strength is full and the number of satellites is 15 or more.
3.1.3 CALIBRATION
Put the activated boat in water first. Then, simultaneously press and hold both the “Point A”
button and the “Point B” button for 3 seconds, to enter the calibration process.
The boat will spin in place to conduct the calibration automatically. When the calibration
completed, the display screen of the remote will give you the success notice. In case of any
failure occurring due to interference, the boat will stop spinning after 40 seconds and
correspondingly give the relevant notice.
3.1.4 FULL MANUAL OPERATION
3.1.4.1 MOVEMENT
Under the Manual Mode, you can control
the boat towards any direction by pushing
the joystick correspondingly.
The highest speed is about 1m/s.
To Next Page
Loading...