Why won't my RIPSpeed DVD-732B switch on?
If your RIPSpeed Car Receiver won't switch on, there are several possible causes. First, make sure your car ignition is turned on. Second, check the cable connections to ensure they are properly connected. Finally, the fuse might be burnt, in which case you should replace it with a new fuse of the same capacity.
What to do if there is no sound from my RIPSpeed DVD-732B Car Receiver?
If your RIPSpeed Car Receiver is not producing any sound, the volume may be set to the minimum level, or the mute function might be activated. Check the volume settings and switch the mute function off.
Why is the radio reception quality poor on my RIPSpeed DVD-732B Car Receiver?
If you are experiencing poor quality reception on your RIPSpeed Car Receiver, it might be due to the antenna not being fully extended or being broken. Fully extend the antenna, and if it is broken, replace it with a new one.
How to fix my RIPSpeed DVD-732B when it is unable to receive stations?
If your RIPSpeed Car Receiver is unable to receive stations, ensure that the antenna is properly connected.
What to do if my RIPSpeed DVD-732B Car Receiver will not play discs?
If your RIPSpeed Car Receiver is not playing discs, ensure that the disc is inserted correctly with the label side facing up. Also, check the disc for dirt or damage; clean it and try another disc.
What to do if the screen of my RIPSpeed DVD-732B does not function normally?
If your RIPSpeed Car Receiver unit or screen is not functioning normally, the unit system may be unstable. Try pressing the RESET button.
Why are the preset stations lost on my RIPSpeed DVD-732B?
If your RIPSpeed Car Receiver's preset stations are lost, the battery cable may not be properly connected. Connect the permanent live on the unit to the permanent live on the vehicle.
Why does the sound skip on my RIPSpeed Car Receiver?
If your RIPSpeed Car Receiver sound skips due to vibration, it could be due to the mounting angle being over 30 degrees. Adjust the mounting angle to less than 30 degrees. Additionally, unstable mounting could be the cause. Mount the unit securely with the supplied parts.
What to do if I am unable to insert USB device into my RIPSpeed DVD-732B?
If you're unable to insert a USB device or SD/MMC card into your RIPSpeed Car Receiver, the memory card or USB device might be inserted the wrong way round. Try inserting it the other way around.
How to fix my RIPSpeed Car Receiver remote control when it is not working?
If your RIPSpeed Car Receiver remote control is not working or not working properly, the batteries may be low or empty. Change the batteries.
General| Display | TFT LCD |
|---|---|
| Output Power | 4 x 45W |
| Remote Control | Yes |
| Media Type | DVD |
| Screen Size | 7 inches |
| Features | USB, SD Card Reader |
| Video System | NTSC/PAL |
| Radio | AM/FM |
| Inputs | USB, SD Card, AUX |
| Outputs | RCA |
To Next Page
